Reely SKY Exceed Notice D'emploi page 52

Roll trim:
If the helicopter tends to drift or tilt to the right, reduce the speed until the helicopter is standing on its skids again
safety, and then push the left one of the two trim buttons for the roll function (also see figure 1, item 4) repeatedly.
Every operation of a button is confirmed by a short signal sound. The percentage shown in the right half of
the display also changes, and the bar display for the tail trimming slowly moves to the left or the right. When
resetting, the centre trimming position (50%) is indicated acoustically with a higher signal sound. The last set
value is stored automatically.
Push the pitch lever carefully forward and check if the adjustment was sufficient. Repeat the procedure until the model
does not show any tendency to drift to the right.
If the helicopter wants to turn or tilt sideways to the right, push the right one of the two trim buttons for the roll function
(see figure 1, item 4).
52
Figure 16