Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6
Safety Notes
6 Gloves should be worn during installation to prevent
crushing and cutting injuries.
6 The hot and cold supplies must be of equal
pressures.
Installation Instructions
• The fitting must be installed, flushed and tested after
the valid norms.
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The fittings must be mounted in an insulated manner
and with sound insulation.
Installation example (see page 31)
4
English
Assembly (see page 32)
1. Plaster in the installed Trio, in case of pre-wall
2. Apply PCI-Lastogum or similar sealing compound
3. Put gasket over the plastic sleeve of the Quattro
Symbol description
Assembly see page 32
installation cover the Trio with a panel.
After the plastered wall surface is dry, seal the gap
between wall and plastic sleeve of the flush valve
with silicone (free from acetic acid!).
on the wall in accordance with manufacturers
indications.
four-way-diverter.
Important! The gasket is not suitable for
hot glue.
If the Trio Stop should be hot glued, please take
care that it is not damaged.
Do not use silicone containing acetic acid!
Dimensions (see page 33)
Spare parts (see page 34)
Special accessories
extension (article number 96370000) order
as an extra
Test certificate (see page 33)
Final assembly (see page 35)
Publicité
Table des Matières
