Appliance Installation; Removing The Appliance; Electrical Connection; Commissioning - LTM E 500 Instructions D'utilisation Et D'installation

INSTALLATION

Commissioning

10.3 Appliance installation

1 Wall mounting bracket
Hook the appliance onto the bottom tabs of the
wall mounting bracket by the slots in the back of the
appliance.
Place the appliance in an upright position.
Secure the appliance by pushing it towards the wall until
it audibly snaps into place in the two upper springs on the
wall mounting bracket.
1
1 Appliance
2 Locking screw
Secure the appliance against unintentional release using
the supplied locking screw on the left-hand side of the
wall mounting bracket.

10.4 Removing the appliance

Undo and remove the locking screw from the wall mount-
ing bracket.
To release the appliance, push down the springs at the top
of the wall mounting bracket.
Tilt the appliance away from the wall and lift it off the bot-
tom tabs on the wall mounting bracket.
22 |

10.5 Electrical connection

1
The appliance is delivered fully wired. The following electrical
connections are permissible:
Connection to a freely accessible standard sock-
et with matching plug
Permanent connection to an appliance junction
box with earth conductor
- If connecting the appliance via a socket, ensure that this is
easily accessible once the appliance has been installed.
- If connecting the appliance permanently, trim the power
cable so that it leads directly to the appliance connection
socket. Ensure that, after trimming the power cable, the
appliance can still be removed from the wall without a
problem.
2
11. Commissioning
The appliance is ready for operation as soon as it has been fixed
to the installation wall and plugged into the mains.
Remove the protective film from the programming unit.

12. Troubleshooting

The power cable must only be replaced (for example if dam-
aged) by a qualified contractor authorised by the manufactur-
er, using an original spare part.

13. Appliance handover

Explain the functions of the appliance to the user. Draw special
attention to the safety instructions. Hand over the operating
and installation instructions to the user.
WARNING Electrocution
- Carry out all electrical connection and installa-
tion work in accordance with relevant regula-
tions.
- In the case of a permanent connection, the ap-
pliance must be able to be separated from the
power supply by an isolator that disconnects all
poles with at least 3 mm contact separation.
- Do not install the appliance with a fixed power
cable.
Note
- Observe the type plate. The specified voltage
must match the mains voltage.
- Ensure the on-site supply cable has an adequate
cross-section.
E 500-3000
X
X
E 500-3000