Settings; Standard Display; Standard Menu; Configuration Menu - LTM E 500 Instructions D'utilisation Et D'installation

OPERATION

Settings

5. Settings
5.1

Standard display

The default display is continuously displayed. If no user action
is performed for longer than 20 seconds while in the menu,
the appliance automatically switches to the default display.
The default display shows the current set room temperature as
well as the "Editable parameter" symbol. You can use " " and
" " to change the set room temperature.
If the set room temperature corresponds to one of the values
set for the comfort or setback temperature, the symbol for the
corresponding operating mode (comfort mode, setback mode)
appears in the menu bar.
The set room temperature can also be changed manually when
in timer mode. The changed set room temperature is main-
tained until the next programmed switching point is reached.

5.2 Standard menu

To access the standard menu, briefly press "M". You can now
call up the following menu items:
Display Description
Select day of the week and time
Select comfort temperature
The comfort temperature must be set at least 0.5 °C high-
er than the setback temperature.
Select setback temperature
Switch "Window open detection" function on and off
Select time program (Pro1, Pro2, Pro3) or deactivate (off)
Switch "Adaptive start" function on and off
To change the setting of a menu item, call it up by pressing " "
and " ". Press the "ok" button.
18 |
As soon as the "Editable parameter" symbol appears, you can
change the setting of the menu item with " " and " ". Press
"ok" to save the setting.
To exit the standard menu, briefly press "M". The standard dis-
play appears.
5.3 Configuration menu
Display Description
I1-I2

Actual values

Pro1-Pro3 Time programs
P1-P5 Parameters
In the configuration menu, you can call up actual values, pro-
gram time programs for timer mode and set parameters.
To access the configuration menu, press and hold "M". After
approx. 3 seconds, actual value I1 is displayed.
Use " " and " " to switch between the individual actual values,
time programs and parameters.
To exit the configuration menu, briefly press "M". The standard
display appears.
5.3.1 Actual values
The following actual values can be called up:
Display Description
I1 Actual room temperature
I2 Relative heating time
(The counter can be reset via parameter P5.)
Note
The counter for relative heating time (I2) counts in
complete hours how long the appliance heats for.
When the appliance is switched off, any heating phase
of less than 60 minutes is not recorded.

5.3.2 Time programs

There are three time programs available for using the appliance
in timer mode. Time programs Pro1 and Pro2 are factory-set.
Time program Pro3 can be set according to your individual
requirements.
Display Description
Pro1 Time program "Daily"
- Repeated: Monday to Sunday
Pro2 Time program "Weekdays"
- Repeated: Monday to Friday
Pro3 Time program "User defined"
- up to 14 comfort phases, freely configurable
Note
To use timer mode, select the required time program
in the standard menu (see chapter "Settings / Standard
menu").
Note
Ensure the day of the week and the time are set cor-
rectly when setting the time programs.
Unit
[°C] | [°F]
[h]
E 500-3000