Care & Maintenance - for_q FQ-ART 4030 BASIC Mode D'emploi

Care & Maintenance
Warning! Before performing
any work on the tool, remove
the battery.
Changing the cutting head
1. Press the lock button 9 and un-
screw the cutting head. Attach new
cutting head and tighten hand-tight.
Replacing the line spool
2. Press both catches together on the
spool cover and remove the cover.
Remove the old line spool and the
spring. Clean the spool housing,
spring and cover. Use a clean cloth.
3. Insert the spring (thin end upwards)
into the spool housing. Pull the line
ends of the new line spool out of the
two opposing retaining slots of the
spool housing (a) and insert the new
line spool.
4. Re-attach the cover to the spool
housing, ensuring that both catches
click into position. Pull on the line
ends to release the lines from the re-
taining slots.
The line blade (b) in the guard cuts
the line back to the correct length if
too much cutting line is released.
1
2
3 4
a
a
b
EN
105