Chattanooga Group MAGNECISER Mode D'emploi page 10

S S E E T T U U P P
A A S S S S E E M M B B L L Y Y ( ( c c o o n n t t i i n n u u e e d d ) )
5. Insert the Locking Knob into the Body
Assembly where appropriate, and turn
it clockwise until it is snug (where the
Front Support Leg does not slide out of
the Body Assembly).
C C A A U U T T I I O O N N : : Do not over-tighten the
6. Insert the threads of the Right Pedal
into the Right Pedal Crank, and with
the wrench, turn it counter clockwise
until it is snug. Repeat this process for
the Left Pedal.
C C A A U U T T I I O O N N : : Do not over-tighten the
7. Plug the wire from the Monitor into
Connector Wire.
8. Slide the Monitor completely onto the
Monitor Tab.
8
Locking Knob.
pedals.