Dometic GROUP WAECO PerfectView M5L Instructions De Montage page 25

_M5L_M7L_M7LX.book Seite 25 Montag, 7. Mai 2012 10:59 10
PerfectView M5L, M7L, M7LX
Observe the following installation instructions:
CAUTION!
!
 Secure the monitor in such a way that it cannot become loose under any cir-
cumstances (sudden braking, accidents) and cause injuries to the occu-
pants of the vehicle.
 Do not attach the monitor in the area that may be used by an airbag, as this
could cause injury if the airbags are triggered.
Observe the following instructions when working with electrical parts:
 When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 1, page 2) or a voltmeter (fig. 1 2, page 2).
Test lamps with an illuminant (fig. 1 3, page 2) take up voltages which are too
high and which can damage the vehicle's electronic system.
 When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (fig. 3, page 3).
 Insulate all connections.
 Secure the cables against mechanical wear with cable binders or insulating tape, for
example to existing cables.
Observe the following instructions when handling the LCD monitor:
CAUTION!
!
 People (including children) whose physical, sensory or mental capacities or
whose lack of experience or knowledge prevent them from using this product
safely should not use it without the supervision or instruction of a responsible
person.
 Do not open the monitor (fig. 4, page 3).
 Do not submerge the monitor in water (fig. 5, page 3); the monitor is not wa-
terproof.
 The monitor may not impair your vision when driving (fig. 8, page 4).
 Do not operate the monitor with wet hands.
 Do not operate the monitor if the housing has been damaged.
EN
Safety and installation instructions
25