Hoover Rush Extra TRE 1420 Mode D'emploi page 5

Cleaning the dust container / multi-cyclonic separation unit
This cleaner uses a multicyclonic separation system, unique to Hoover. If necessary the
separation unit can be disassembled from the dust container and cleaned.
1. Release the dust container by sliding the dust container release button towards the
rear of the cleaner. [13] lift the dust container from the cleaner main body.
2. Hold the dust container with one hand and with the other hand rotate the dust
container handle anti clockwise to release it from the dust container. [15]
3. Remove the multicyclonic separation unit from the dust container by pulling the
handle provided. [20]
4. If necessary, use a cloth to remove excessive dust from the multi-cyclonic unit surface.
[21]
5. Reassemble the multicyclonic separation unit to the dust container and refit the filter
pack in position.
6. Reassemble the dust container handle to the bin container. Refit the dust container to
the cleaner.
note: for stubborn dirt the multi-cyclonic separation unit, or the dust container can be
washed, but care must be taken to ensure that both are completely dry before use.
important: for optimum performance, we recommend that the multi-cyclonic separation
system is inspected after each empty.
removing a Blockage From the System
1. check if the dust container is full. If so refer to 'Emptying the dust container' .
2. If the dust container is empty but suction is still low:
A. Do the filters need cleaning? If so refer to 'cleaning the washable filters' .
b. check if there is any other blockage in the system - Use a rod or a pole to remove
any blockage from the extension tube or flexible hose.
c. check if pre-motor filter is fitted.
D. check if the separation unit needs to be cleaned. Refer to 'cleaning the separation
unit' .
RushExtra__1-4_union.indd 3
USER cHEcKlIST
Should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance
• Is the dust container over-filled? Please refer to 'cleaner Maintenance' . '
• Is the filter blocked? Please refer to 'cleaner Maintenance' . '
• Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the system' . '
• Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically
reset.
IMPORTANT INfORMATION
hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoover
dealer or direct from Hoover. when ordering parts always quote your model number.
Consumables:
• Hepa / foam filter pack:
Spares:
• carpet and floor Nozzle:
• flexible Hose:
• Stretch Hose:
• Grand Turbo Nozzle:
• Mini Turbo Nozzle:
• Parquet caresse Nozzle:
hoover Service
Should you require service at any time, please contact your local Hoover Service Office.
3
gB
U64 35601223
G140 35601226
D132 35601224
D133 35601225
J55 35601206
J56 35601227
G133Pc 35601205
22/07/2011 16.02.16