D-Link DSR-150N Guide D'installation page 4

Connecting the Device to a Network
This section provides basic knowledge of how to
connect DSR-150N to network.
Necessary connecting cables and steps are
shown below:
1. Connecting a RJ-45 cable from the port
labeled WAN to the external router, cable or
ADSL modem. The port WAN is pre-allocated
to the WAN network segment.
2. Connecting a RJ-45 cable from the port
labeled LAN (1-8) to PCs in the LAN network
segment.
3. Connecting a RJ45-to-DB9 cable from the
console port for CLI (Command Line Interface)
for management access.
Users
Figure 4: Basic Cabling Example
Initially Configure the Device
DSR-150N preinstall services router software
and is ready to be further configured after startup
completion. Although the device has preconfigured
with factory default settings allowing you to
initialize connections to the device, we still highly
recommend you to customized configurations for
your specific network requirements.
Using the Web User Interface
To use the Web User Interface (WebUI) to manage
DSR-150N, the workstation from which you
manage the device must be in the same subnet
as the device.
4  D-Link Wireless N Services Router
Internet
WAN
Console
LAN
Administrators
Browser
Microsoft Internet
Explorer
Mozilla Firefox
Netscape Navigator
Apple Safari
Google Chrome
Table 5: Browser Compatibility
To access the device with the WebUI:
1. Connect your workstation on the port labeled
LAN (1-8), which is pre-allocated to the LAN.
2. Ensure your workstation is DHCP Client
enabled or manually assigned a static IP
address in the 192.168.10.0/24 subnet.
Note: Disable pop-up blocking software
or add the management IP address
http://192.168.10.1 to your pop-up blocker'
allow list.
3. Launch your browser; enter the IP address
for the LAN interface. (The factory default IP
address is http://192.168.10.1), then press
Enter.
Figure 5. Browser Address
4. Log on the Services Router Web Interface The
default log on information is:
Username: admin
Password: admin
Figure 6. Authentication Message
Version
6.0 and Later
3.5 and Later
9.0 and Later
4.0 and Later
3.0 and Later