Electrical Connection; Important; Disposing Of The Packaging; Disposing Of Your Old Refrigerator - Beko RDNE350K20X Manuel D'utilisation

Electrical connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.

Important:

The connection must be in compliance
with national regulations.
The power plug must be easily
accessible after installation.
Electrical safety of your refrigerator shall
be guaranteed only if the earth system
in your house complies with standards.
The voltage stated on the label located
at left inner side of your product should
be equal to your network voltage.
Extension cables and multi plugs must
not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated before
it is repaired! There is the risk of electric
shock!

Disposing of the packaging

The packing materials may be
dangerous for children. Keep the
packing materials out of the reach
of children or dispose of them by
classifying them in accordance with the
waste instructions stated by your local
authorities. Do not throw away with
regular house waste, throw away on
packaging pick up spots designated by
the local authorities.
The packing of your refrigerator is
produced from recyclable materials.
Disposing of your old
refrigerator
Dispose of your old refrigerator without
giving any harm to the environment.
You may consult your authorized
dealer or waste collection center of
your municipality about the disposal of
your refrigerator.
Before disposing of your refrigerator,
cut out the electric plug and, if there
are any locks on the door, make them
inoperable in order to protect children
against any danger.

Placing and Installation

A
If the entrance door of the room
where the refrigerator will be installed is
not wide enough for the refrigerator to
pass through, then call the authorized
service to have them remove the
doors of your refrigerator and pass it
sideways through the door.
Install your refrigerator to a
1.
place that allows ease of use.
Keep your refrigerator away
2.
from heat sources, humid places and
direct sunlight.
Do not place your product on
3.
the materials such as rug or carpet.
Place your refrigerator on an
4.
even floor surface to prevent jolts.
Your product requires adequate
5.
air circulation to function efficiently. If
the product will be placed in an alcove,
remember to leave at least 5 cm
clearance between the product and
the ceiling, rear wall and the side walls.
If the product will be placed in
6.
an alcove, remember to leave at least
5 cm clearance between the product
and the ceiling, rear wall and the side
walls. Check if the rear wall clearance
protection component is present at its
location (if provided with the product).
If the component is not available, or if
it is lost or fallen, position the product
so that at least 5 cm clearance shall
be left between the rear surface of the
product and the wall of the room. The
clearance at the rear is important for
efficient operation of the product.
10
EN