Sharp AN-52AG2 Mode D'emploi page 22

Installing the Wall-mount Brackets
Install the wall-mount brackets to the LCD television.
3
Install the wall-mount brackets without an angle being set (0° setting).
1 Align the wall-mount bracket screw holes (4 locations) to the LCD color TV back
holes(4 locations).
2
Use the 4 TV installation screws B (M6, 12mm length) that came with the TV to
mount the bracket on the TV.
* When there are caps in the 4 holes on the back of the LCD color TV, remove these
ahead of time.
* Position the wall-mount brackets so that the screw heads of the angle holding
screws face the outside. The wall-mount bracket label (L/R) is displayed as seen
from the back of the television.
4
Setting the Angle of the Wall-mount brackets
*For details regarding the angle setting method, refer to "Setting the Angle of the Wall-mount
Brackets" on page 9.
E-8
(Continued)