Using Your Activhub Tm Rf50; Powering The Activhub; Selecting The Synchronization Source - Volfoni ACTIVHUB RF50 Manuel D'utilisation

Using seemingly compatible, yet non-Volfoni, glasses
with the ActivHub RF50 will most likely generate timing
TM
issues and degrade the 3D image quality, color fidelity,
sharpness and brightness. This may cause unwanted
eyestrain or fatigue.
These compatibility lists are indicatives. Due to possible
changes of protocol by manufacturers, Volfoni cannot
warranty compatibility with products previously cited
3. Using your ActivHub RF50
TM

3.1 Powering the ActivHub

RF50
TM
The ActivHub RF50 gets its power either from
TM
the Jack or micro-USB ports. Do not plug both
inputs to power-providing devices at once, this
may damage the ActivHub or the host systems.
TM
The VESA port should be powered with either 5v or 12v. If
your VESA is not powered, then the ActivHub RF50 can
TM
be powered via its USB port. In this case, make sure to use
an optional universal adapter rather than a powered USB
port on an electronic device.

3.2 Selecting the synchronization source

Synchronization source selection is automatic on the
ActivHub RF50. At power-on, synchronization sources
TM
like VESA, DLP-Link and IR, are automatically checked
TM
by the ActivHub . As soon as any of these three signals is
TM
detected, the ActivHub will focus exclusively on it until its
TM
next full power cycle. To switch to another synchronization
source, you need to power off the ActivHub RF50.
TM
8