Volfoni ACTIVHUB RF50 Manuel D'utilisation page 11

Notes :
• The ActivHub
signals 3D sync input and its RF transmission.
• DLP-link
TM
between the ActivHub
• Because DLP-link
it is very sensitive to ambient light. Optimal positions for
the ActivHub
-Close to the projector, turned toward the output lens
-Close to the projector, turned toward the screen
-Close to the screen edge, turned toward the projector
• If you experience interferences, or if you are using
many ActivHub
may choose another channel between 3 and E.
Note: Using Volfoni RF glasses require to update them
with a RF software.It can be downloaded from volfoni
website: www.volfoni.com.
4. RF (Volfoni) > VESA mode
1. Set the function selector to position F.
2. Plug the USB connector to a powered socket or an
optional adapter.
3. Plug the micro-USB connector to the ActivHub
4. Check the blue LEDs light up to signal power on.
5. Emit RF signal with another AcvtivHub
function selector to position 3-E.
6. Check the blue LEDs starts blinking three times every
three seconds.
7. At the output of the first ActivHub
VESA signal.
8. If you want you can put a Volfoni IR emitter at the
output of this ActuvHub
RF50 blinking twice means a functional
TM
receiving mode requires a clear line-of-sight
TM
signal is in the visible light spectrum,
TM
are:
TM
RF50 in a single room or building, you
TM
and the 3D image or source..
RF50.
TM
RF50 (with
TM
RF50 there is a
TM
RF50.
TM
11