4. ADVANCED USES
Battery monitoring (only with EDGE
VR)
TM
To enable the battery monitoring you need to plug your
ActivHub
RF50 to your computer via USB. Launch the
TM
Volfoni Loader (available on www.volfoni.com section
"Support"), click on battery (menu "Edition").
The
popup will show you the battery level of all the glasses
synchronised with the ActivHub
RF50
TM
5. LED SIGNIFICANCES
LED OFF: no power
Continuous light: The ActivHub
RF50 is powered but
TM
there is no 3D source.
LED blinks once: Auto-Test Mode (emit RF Volfoni signal
at 60Hz)
LED blinks twice: 3D input OK, and the ActivHub
emits
TM
in RF mode.
LED blinks three times : 3D input OK and the ActivHub
TM
RF50 emits a VESA 3D synchronization signal
12