RM SPB - 704 G Notice D'installation Et D'emploi page 11

INSTRUCTIONS FOR USE
gnition of the burner and regulation of the performance :
Turn the regulation knob of the competent burner (A) into position „ignition of the main burner" and then press
it down and hold it. Ignite the burner with lighter or matches. After ignition of the burner hold the knob (A)
pressed several seconds till the thermofuse gets hot. Then release the button. If the fl ame goes out repeat
the whole process once more.
Lower performance sporo:
By turning the knob (A) into position „sporo" you set the burning of the burner for sporo (lower performance)
How to switch the burner off:
Turn the knob (A) into position"0".
Instructions for sucking off the gas products of combustion:
Type A devices (see the label with characteristics). Appliance of fi nish A, that is the appliance which is not
made for being connected with the chimney or other device for sucking off the products of combustion out
of the space where the appliance is situated. These appliances must be situated in the room with suffi cient
ventilation according to the ČSN 12 7010:1986 and ČSN 1207040:1986. It is necessary to prevent the
accumulation of the harmfull matters in big concentration (secure the requestment of hygienic standard for
working surrounding sv. 39/78 guideline 46).
11
Switched off
Full power
Lowered power