Ordering Replacement Parts; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL EF 1800 Instructions D'origine

6.9 Activating the automatic timer (Fig. 9)
Switch off the equipment with the "POWER"
button (D). The equipment will switch on at the
next switching point with the last heating function,
desired temperature and fl ame eff ect to have
been set.
6.10 "Windows open" function
If the temperature drops by 5°C within 10 minutes
while the heating function is switched on, a signal
will sound for several seconds and the heating
function will switch off .
6.11 Overheating protection
In case of excessive heating, the heat output or
the equipment will shut down automatically. In
this case switch off the equipment completely
and unplug it from the mains power. Allow the
appliance to cool for about 15 minutes. After
eliminating the cause (e.g. a covered air grille),
the equipment can be switched on again as
described above. If the overheating guard triggers
repeatedly or the equipment cannot be switched
on, please contact your customer services
workshop.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before
starting any cleaning work.
The equipment must have cooled down.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible.
•
Remove dust with a vacuum cleaner.
•
Clean the equipment regularly with a damp
cloth. Do not use cleaning agents or solvents;
these may be aggressive to the plastic parts
in the equipment. Ensure that no water can
Anl_EF_1800_SPK9.indb 25 Anl_EF_1800_SPK9.indb 25
GB
get into the interior of the equipment. The
ingress of water into an electric power tool
increases the risk of an electric shock.
•
The glass front can be cleaned with a
conventional glass cleaning agent.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
Heating elements or the LEDs used for the
fl ame eff ect may only be replaced by a qualifi ed
electrician or by the customer service authorized
by Einhell in compliance with the relevant
regulations.

8.3 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 25 -
22.11.2018 06:58:50 22.11.2018 06:58:50