General Assembly Instructions - Vacmaster Professional VJF912PF 0201 Manuel D'utilisation

GENERAL ASSEMBLY INSTRUCTIONS

A Philips head screwdriver is required.
1
6
11
15
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY
VACUUM. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on page 7 (Fig. 4).
5. Turn the collection tank upside down and insert the four caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screws (Fig. 5).
6. Position the hose storage rack as illustrated. Squeeze the open sides of the hose storage rack
inward. Insert the hose storage rack into the channel on the front side of the power head just
above the top edge of the tank. Verify that the rack is secured in place as shown in Fig. 8. Then
squeeze in the other hose storage rack and insert it into the corresponding channel making sure
it is secured (Fig. 6 - 9).
2
7
12 13
16
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
4
3
9
8
14
8
5
10