Symbols; Instruction; Cleaning; Safety - Nieaf-Smitt VoltBeeper Plus Mode D'emploi

Symbols on the instrument and in the instruction manual
Warns of potential danger, consult instruction manual.
Equipment protected by double or reinforced insulation.
Symbol of conformity, confirms conformity with relevant
EU directives.
The instrument complies with the EMC directive (2014/30/EU) as
well as the low Voltage Directive (2014/35/EU) described in the
standard EN 61010-1.
Instructions
The contact-free voltage detector has been developed for voltage
detecting on (insulated) cables and conductors.
Power is supplied by 2 batteries AAA, 1.5 Volt IEC LR 03 (included).

Cleaning

Use a damp cloth with household cleaner and wipe the surface by
applying light pressure. Do not use the tester till it is completely dry.
Safety measures
The instrument has left our factory in a safe and perfect condition.
To maintain this condition, the user must pay attention to the safety
references contained in this instruction manual.
Warning
This instruction manual contains both information and warnings
that are necessary for the safe operation and maintenance of the
instrument. It is recommended that you read the manual carefully
and ensure that its contents are fully understood. Failure to
understand these instructions and to comply with the warnings and
instructions contained herein can result in serious injury or damage.
Warning
Prior to using the device, you should always test it on a known main
circuit to ensure the correct working within the specified voltage
range. To avoid inaccurate measurements, check the device
batteries prior to use by switching on the built-in flashlight
Nieaf-Smitt is a brand name of Mors Smitt
10
www.nieaf-smitt.com