Battery Replacement; Parts Voltbeeper Plus; Operation - Nieaf-Smitt VoltBeeper Plus Mode D'emploi

Battery replacement

• Press on the battery clip to release the battery compartment
on the bottom by holding the grip on both sides
• Insert the batteries by respecting the correct polarity
• Remount the battery compartment careful until latching

Parts VoltBeeper Plus

1. Test probe with LED for voltage indication
2. ON/OFF button
3. Grip
4. Battery release clip
5. Flashlight ON/OFF
6. Flashlight

Operation

Warning
Prior to using the device, you should always test it on a known
main circuit to ensure the correct working within the specified
voltage range. To avoid inaccurate measurements, check the device
batteries prior to use by switching on the built-in flashlight.
1. Press the on/off button to turn on the voltage tester. A double
beep indicates the device is turned on. The self-testing will be
undergone throughout normal operation. The detector tip will
flash to indicate normal operation
2. Use the detector according to one of the application examples
below. Once a Live AC voltage is detected, the tip glows and
beeper sounds.
3. The voltage tester will turn off automatically after about 3
minutes of being idle. Otherwise, press and hold the on/off
button to turn off the voltage tester. A long beep indicate that
the device is turned off.
Nieaf-Smitt is a brand name of Mors Smitt
12
www.nieaf-smitt.com
1
2
3
4
5
6