Ugur UDD 45 DTK Guide D'emploi page 26

D- USING YOUR PRODUCT
Defrosting
Your product has manual defrost.
If there is excessive frost deposit on the shelves of your device, this will lead decrease in the cooling capacity
and increase in energy consumption.
If the frost deposit and its thickness are high, place the products inside of your device to another suitable
environment that prevents them to get spoiled.
Unplug your product. Frost deposit generally melts in two (2) hours.
Place a container at water discharge for preventing the melted ice waters to damage the floor.
After defrosting operation, wipe internal walls with a dry cloth to make sure that they are not wet.
Run your device empty again for three (3) hours and wait for it to cool down. Then you can place your foods-
tuff in it.
EN
50
D- USING YOUR PRODUCT
Shutting down your product
Transfer the foodstuff inside your product to a convenient place.
Unplug your product. (Picture 14)
If your product will not be used for a long time, apply following considerations;
Clean your product. Otherwise the humidity on the wall may cause darkening of the internal surface.
PICTURE 14
CAUTION!
If your product will be stored at an indoor place after shutdown;
• Do not cover it with plastic sheets. Plastic will cause smell and sweating of your product as
it does not breathe. Corrosion may be seen as the result of sweating.
• Smell formation may occur in cases where you fail to store your product with the door
open.
51
EN