Hands-Free Function - Hama Trexis Mode D'emploi

Note
• If pairing was successful, the status LED (6)
flashes blue every 3 seconds.
• If pairing was not successful, the status LED
(6) flashes blue every 5 seconds, and you will
have to perform pairing again.
• You can now use the headset.
5.2. Automatic Bluetooth
successful pairing)
Note
• Make sure that your Bluetooth
terminal device is on and Bluetooth
activated.
• Make sure that your Bluetooth
terminal device is visible for other Bluetooth
devices.
• For more information, please refer to the
operating instructions of your terminal device.
• Make sure that the headset is switched on.
• After the headset and terminal device have been
paired, a connection is established automatically.
• You can now use the headset.
4
connection (after
®
-capable
®
is
®
-capable
®
®
Note
• If pairing was successful, the status LED (6)
flashes blue every 3 seconds.
• If pairing was not successful, the status LED
(6) flashes blue every 5 seconds, and you will
have to perform pairing again.
• It may be necessary to change the settings
on your terminal device to enable it to
automatically connect to the paired headset.
Note – Connection impaired
After the headset and terminal device have been
paired, a connection is established automatically.
If the Bluetooth connection is not established
®
automatically, check the following:
• Check the Bluetooth
terminal device to see whether Hama Trexis is
connected. If not, repeat the steps listed under
5.1. Bluetooth
®
• Check whether obstacles are impairing the
range. If so, move the devices closer together.
• The performance can also be affected by a
weak battery.

5.3 Hands-free function

Note
• Note that support for certain key functions
may vary depending on your terminal device.
• For more information, please refer to the
operating instructions of your terminal device.
You can use the headset as a hands-free set for your
mobile phone.
settings of your
®
pairing.