Hands-Free Function; Accepting Calls - Hama Style Mode D'emploi

• Remove the earphones from the charging box at the same time. A
voice says, 'Power on – Connected'.
• After the headset and terminal device have been paired, a
connection is established automatically.
• You can now use the earphones.
Note
• If pairing was successful, the status LEDs of the earphones (5)
slowly flash blue. A voice says, 'Connected'.
• It may be necessary to change the settings on your terminal
device to enable it to automatically connect to the paired
earphones.
Note - Connection impaired
After the headset and terminal device have been paired, a
connection is established automatically. If the Bluetooth
connection is not established automatically, check the following:
• Go to the Bluetooth
whether the Hama Style earphones are connected. If not, repeat
the steps listed under 5.1 Bluetooth
• Check whether obstacles are impairing the range. If so, move the
devices closer together.
• The performance can also be affected by a weak battery.

5.3. Hands-free function

Note
• Note that support for certain key functions may vary depending
on your terminal device.
• For more information, please refer to the operating instructions of
your terminal device.
You can use the earphones as a hands-free set for your mobile phone.
Making a call
• Dial the number directly on your terminal device to make a call.

Accepting calls

• Tap the Multifunction touch sensor (3) on the left or right
earphone twice to accept an incoming call. Alternatively, you can
use your telephone to accept a call.
6
settings on your terminal device and check
®
pairing.
®
®