Remington MB4045 Mode D'emploi page 6

Masquer les pouces Voir aussi pour MB4045:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
ENGLISH
, Please note that the adjustable zoom wheel does not increase the length
settings on the stubble comb. To adjust these length settings, turn the dial
found on the back of the stubble comb which will then indicate the different
trimming lengths to choose from.
, Note: The below instructions are recommended for those with or wanting to
trim beard hair between 1.5 to 18mm in length.
, TO THIN AND TAPER THE BEARD/MOUSTACHE
Turn the unit on.
Place the flat top of the trimmer comb against the skin.
Slowly slide the trimmer through the hair. Repeat from different directions as
necessary.
If hair builds up in the trimmer comb during the trimming process, switch
the unit off, pull off the comb and brush off.
, DETAILING
To create sharp lines around your beard, press the pop-up trimmer release
button.
Start with the edge of the beard/moustache line and gently lower the
trimmer blade onto your skin. Use motions towards the edge of the beard/
moustache line to trim to the desired locations in the facial area and away
from beard in neck area.
, TRIMMING AND STYLING LONGER BEARDS
To take out volume from your beard or if you want to take down the length
significantly, select your desired length setting on the XL comb (please see
the table for trimming length settings). Place the flat top of the trimmer comb
against the skin. Slowly slide through the hair. Repeat from different
directions as necessary.
If hair builds up in the trimmer comb during the trimming process, switch the
unit off, pull off the comb and brush the hair off.
, HOW TO BLEND/TAPER YOUR BEARD
Tapering is when you fade the length of your beard from shorter sideburns to
a longer beard. This is how you can truly stlye your beard based on different
lengths and shapes.
1
Adjust the comb to your selected grade.
2
Grade settings and the respective trimming lengths the beard kit offers can
be seen in the table. You will either need to use the short length adjustable
comb or the XL adjustable comb depending on the grade you require. If you
don't know, you can start at a longer trimming setting and work up towards
your hairline, lowering the grade number as you go.
6

Publicité

Table des Matières
loading

Table des Matières