Novy Flat'line 7600 Mode D'emploi Et D'installation page 12

Operation
① switch on / off
② decrease speed levels
⑤ and ⑥ speed indicator lamps
③ increase speed levels
④ illumination
Switch on – switch off
To switch the motor on push button ①.
The hood will always resume the level it was previously
switched off in.
Auto-Stop
To avoid that the hood will function during a too long
period, it will switch off automatically after 3
hours (when no changes to the controls have been
made). Only the motor will turn off automatically. The
lighting will stay on.
Switch off with 10 minute delay:
Press button ① once. The first green speed indicator
lamp blinks, the other speed indicator lamps remain lit
up according to the level in use. After 10 minutes motor
and illumination switch off automatically.
Switch off without delay:
Push button ① twice.
Levels of intensity
To decrease speed levels push button ②. To increase
speed levels push button ③.
Three green speed indicator lamps ⑤ indicate level 1 to
3, one red speed indicator lamp ⑥ indicates the level
'POWER'.
POWER' is only used in case of excessive formation of
smoke, fumes or odours. Taking into account the large
volume of air which is extracted from the room at this
level, it's use should be limited.
'POWER' automatically reverts to level 3 after 6
minutes.
A self-rectifying thermal contact makes sure that the
motor is switched off when overheated. The motor will
switch on again after is has cooled down. The cause of
the overheating needs to be determined. This may be,
for example, that the contents of the pan have caught
fire, the motor fan is blocked or an object is (partly)
closing off the exhaust opening.
Lighting
Press key ④ to switch the lighting on or off. The LED
lighting has a soft on/soft off mode, which means that
the lighting will evenly go on and off. When switching
on the lighting, this will always light up with full power
and it can also be used when the fan is off.
Dimming LED lighting:
When the LED lighting has been switched on, it can be
dimmed by keeping key ④ pressed.
Maintenance
Maintenance of the grease filter
The hood contains one or 2 metal filters (according to
the model) which should be cleaned twice a month.
Grease filter indication
After 20 cooking hours, the 4 speed indicator lamps
will start to blink during 5 minutes, this indicates that
the grease filter has to be cleaned. When replacing the
cleaned filter, you have to reset the hood by pushing
the – button during 5 seconds . If you don't reset, the
speed indicator lamps will continu blinking.
Access to the filter
Take hold of the right and left side of the plate (a) an pull
down simultaneously. Remove the filter (b) by taking
hold of its hook and by pulling it down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a liquid de-
tergent. Rince and allow to dry completely
Important! The previous instructions need to be
followed. If not an increased fire hazard may occur.
Maintenance of the hood
Please allow the lights to cool down sufficiently before
cleaning the hood. Use a soft, wet cloth and a mild
detergent to clean the hood. Never use aggressive,
abrasive detergents or sponges. Bleach will damage
stainless steel.
The stainless steel surfaces can be treated with Novy
Inoxcleaner (906.060) after cleaning.
EN 12