Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. SPECIFICATIONS OF THE APPLIANCE
Voltage: 230 V~ 50 Hz
Insulation class: II
GB
Protection class: IP24
Power [W] Length [cm]
700
47
1000
54
1500
82
2000
103
Table 1
The technical specifications of the appliance are
indicated on the rating plate on the side of the ra-
diator (Fig. 1).
A Brand/Manufacturer
B Model, type, category
C Bidimensional Code (QR)
D Protection class
E CE marking
2. GENERAL INFORMATION
Unpack the appliance carefully and rest it on the
polystyrene corner pieces or a carpet.
The package contains:
– the appliance
– mounting kit
– instructions
Read all the instructions carefully before installation
and use. Keep for future consultation.
Install and use the appliance as described in these
instructions only.
These instructions do not cover all situations which
might arise. Caution and common sense should be
applied when installing, operating and servicing the
appliance.
Modifying the characteristics of the appliance and
removing any fixed component including the caps
is expressly prohibited. Make sure the appliance is
complete and undamaged. If damaged, do not use
the appliance, but contact your local dealer or a
qualified professional.
The materials used for packaging can be recycled.
You are therefore recommended to dispose of them
in special differentiated waste collection containers.
Height
Weight
Rated current
[cm]
[kg]
[A]
58
15,5
3
58
17,8
4,3
58
23
6,5
58
30,5
8,6
F Double insulation
G Disposal procedures
H Quality marks
I
Voltage and Power
L Serial number
3. POSITIONING AND INSTALLING
The appliance is designed to heat domestic rooms
or similar. It must not be used for other purposes.
The appliance must be used permanently mounted
on a wall as described in the instructions. Install the
appliance with the thermostat at the bottom (Fig. 2).
In bathrooms (with bath or shower), install the ap-
pliance outside zone 1.
The appliance must be installed in such a way that
the electronic controls and other control devices
may not be touched by someone in the bath or
shower. The appliance must not be connected with
a plug.
For radiators already fitted with power
plugs, see the warnings on page 23.
Respect the distances shown in figures 3,4.
Never install the appliance:
– immediately below or in front of a power socket or
a junction box (Fig. 5)
– in contact with the wall or floor
– near curtains, flammable or combustible materials
or pressure vessels.
Make sure there are no pipes or electric wires in the
wall which could be damaged while mounting the
appliance.
The appliance is equipped with a sensor which can
detect an open window, if present above the radia-
tor or within the room. For a proper operation, it
is strongly recommended to comply to the instal-
lation directions reported in Ch. 4.3.2 before wall
mounting.
3.1 WALL MOUNTING
Screws and anchors not included
Make sure the screws and anchors are suitable for
the type of wall on which you are mounting the
appliance. If in doubt, contact a qualified profes-
sional or your local dealer.
During installation, make sure the power cable is
disconnected from the power line.
Follow the installation sequence shown on the
folding leaf of the cover (Scheme 1), respecting
the minimum distance between the bottom of the
radiator and the floor (Fig. 3).
14
Publicité
Table des Matières
