Troubleshooting - Vax Air Cordless U86-AL-B-E Mode D'emploi

Troubleshooting

WARNING: To reduce the risk of personal injury, unplug the stick vac before performing maintenance/
troubleshooting checks.
Problem
Why does my stick
vac have no power?
Why won't the stick
vac pick up?
Why isn't the
brushbar turning?
Why isn't the
battery charger light
lit when the battery
is charging?
Why is the battery
charger light
continually flashing?
30
Solution
• Check the battery is inserted correctly into the stick vac.
• The battery may not be charged, remove and charge battery.
• Battery might be too hot, remove and allow to cool for 30
minutes. Replace battery.
• The motor thermostat may have tripped. If this has happened,
switch off the stick vac. Remove and empty the dirt container
and check for blockages. Clean the filters and allow the stick vac
to cool for approximately 1 hour (if you have washed the filters
you will need to wait 24 hours for the filters to fully dry before
putting them back into the stick vac).
• Empty the dirt container and clean filters. Go to 'Maintenance',
page 28.
• There may be a blockage in the stick vac. Check hose, handle
and brushbar.
• The brushbar may not be turning. Go to 'Why isn't the brushbar
turning?' below.
• The brushbar may not be switched on, please check the
brushbar on/off switch.
• The brushbar may be obstructed. Go to 'Maintenance', page
29.
• Check the battery charger is plugged in.
• Check the battery is inserted correctly into the charger.
• The battery may not be connecting with the charger. Remove
battery and unplug charger, wait 10 seconds then retry.
• Check the battery is inserted correctly into the charger.
• The battery or charger has an error. Remove the battery and
unplug charger, wait 10 seconds then plug charger into socket
and reinsert the battery.
• Check terminals on battery and stick vac are clean.
Go to 'Maintenance', page 28.