Electrical Safety - Black & Decker DVA315J Mode D'emploi

Electrical safety

Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
rechargeable batteries.
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
placed in a well ventilated area when
charging.
Features
ENGLISH
Symbols on the charger
Labels on appliance
Read all of this manual carefully before using the
appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
The charger is intended for indoor use only.
The following symbols appear on this appliance along with the
date code.
Read all of this manual carefully before
using the appliance
Only use with charger S003AQ-15
This tool includes some or all of the following features.
2. Dust chamber release button
3. Dust chamber
4. Flip down brush
5. Wall bracket
6. Charger
7. Hanging attatchment
6
u
u
#
+
$
u
u
u
The appliance/battery must be
u
S003AQ-15
1. On/off power switch
(Original instructions)
Use
Switching on and off (Fig. A)
Flip down brush (Fig. B)
Using the pull out crevice tool (Fig. C)
Fitting the wall bracket (Fig. D)
Charging (Fig. E, F)
turn on the unit.
Flip the brush attachment (4) into position as shown in
clicks in place.
Note: The flip down brush (4) can only be utilised when the
crevice tool is in the retracted position.
Fit the wall bracket (5) to a suitable wall (preferably near a
power outlet) using the screws provided.
The unit can then be stored, when not in use, or during the
charging procedure, utilising the hanging attachment (7).
Place the charger (6) into the charging port (9) on the
Place the charging plug into a power outlet and switch on
Press the dust chamber release button (2) as shown in
Seperate the dust chamber (3) from the motor unit as
Lift the filter (8) out of the dust chamber (3) using the tab
(10) provided.
Empty the dust bowl (3) by lightly shaking over a suitable
Rinse out the dust-bowl with warm soapy water.
L.
the dust chamber backwards.
Replace the dust chamber onto the motor unit. Make sure
the release button (2) clicks into place.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.
Push the On/off power switch (1) to the forward position to
u
Returning the On/off power (1) switch will turn the unit off.
u
u
figure B.
Extend the crevice tool (8) as shown in figure C, until it
u
u
u
u
handle of the unit as shown in figure E.
u
as shown in figure F. The charger LED will light.
Cleaning the filters (Fig. G, H, I, J, K)
u
figure G.
u
shown in figure F.
You can use the easy empty feature as shown in figure I.
u
u
u
container as shown in figure K.
u
Wash the filters with warm soapy water as shown in figure
u
Allow the filters to dry naturally, using heat may cause the
u
filters to distort.
Refit the filter (8) into dust chamber (3). Make sure the
u
filter tabs (11) face forward. Never place the filters into
u