Carat P-7010 Mode D'emploi page 43

5
MOVE THE MACHINE AS INDICATED IN
PICTURE 6
6
POSITIONING
Place the machine on a stabile surface.
To place the machine in working position, proceed
as follows:
CAUTION!
MAKE SURE THAT THE MOTOR HEAD IS
LOCKED BY MEANS OF THE LOCKING KNOB
LOCATED ON THE SLIDE RAIL (see picture 9).
a) put the leg locking pins in release position (see
picture 7);
b) by means of the transport handles, lift one side
of the machine until the working position (see
picture 7).
7
FOR CORRECT MACHINE POSITIONING, MAKE
SURE THAT THE LEG UPPER HOLE MATCHES
THE LEG COUPLING HOLE, BEFORE FINALLY
LOCKING IT (SEE PICTURE 8).
c) lock the legs one at a time (see picture 8).
8
CAUTION!
HOLD THE MACHINE DURING THE LOCKING
PHASES.
d) Repeat the operation for the opposite side;
e) Loosen the carriage locking knob located on the
slide rail (see picture 9);
9
43
GB