Carat P-7010 Mode D'emploi page 42

GB
7. Installation
TRANSPORT
The P-7010 machine can be easily moved by using
the transport handles.
Before carrying the machine make sure that:
- the motor carriage is locked by means of
the locking knob located on the slide rail
(see picture 9);
- the tube-holder rod is out of its housing
(see picture 12);
- the legs are in transport position (see picture 3).
3
To move the machine, use a four-arm tie rod
with the capacity to lift 200 kg or at least 20%
more than the machine weight, by making
use of the hooks in the transport handles
(see picture 3).
HANDLING
By using the "transport wheels" accessory, the
machine can be moved with the aid of a second
person.
CAUTION!
IN ORDER NOT
MACHINE STABILITY, KEEP STRICTLY TO THE
FOLLOWING PROCEDURES.
WITH THE AID OF A SECOND PERSON, HOLD
THE MACHINE DURING THE WHEEL KIT
INSTALLATION OPERATIONS.
TO COMPROMISE
When the
(See paragraph: Positioning):
a) loosen the left leg locking pin (motor side);
b) lift the leg and put it in the wheel support (see
picture 4);
c) lock the leg with the relative locking pin;
d) tighten
(see picture 4);
e) repeat the operation for the right wheel.
4
CAUTION!
IN ORDER TO FACILITATE THE P-7010 MACHINE
MOVEMENT IN THE YARD, WE RECOMMEND
LOWERING IT UNTIL THE LOWERED POSITION
WITH THE AID OF A SECOND PERSON AS
DESCRIBED BELOW:
a) loosen the leg locking pins on the front side, one
at a time, holding the machine from the transport
handles;
b) lower the machine front side, making the legs
slide inside the supports until the leg middle hole
matches the hole of the supports;
c) lock the legs by means of the relevant leg
locking pins;
d) repeat the operations indicated in points (a), (b),
(c) for the rear side.
THE
42
machine is in working
the wheel support
position
setscrew