Maintenance; Changing The Paper Dust Bag - KENT S12 Mode D'emploi

Always disconnect the power cord before
performing any machine maintenance.

CHANGING THE PAPER DUST BAG

Change the bag whenever the "Bag Full"
tor comes on. To replace the Paper Dust Bag:
1. Disconnect the power cord from the electrical outlet. Pull
the Dust lid button (16) and remove the Dust lid outwards
to remove it from the cleaner.
2. Push downwards at the edge to the left of the plastic
holder, so that the bag loosens from the vacuum inlet of
the machine.
3. Grasp at the cardboard piece of the bag and gently pull
the full bag outwards - away from cleaner.
4. Insert a new paper dust bag into the slot of the bag holder
and push the bag in place. Check so that the paper dust
bag not is jammed in the holder.Only the cardboard piece
of the bag should be attached to the bag holder.
5. Push the bag holder with the new bag upwards, so that
the bag inlet fastens to the inlet of the machine. Make
sure that the bag is unfolded and will fi t in place in the
bag housing. Also check that the "no bag" clip is placed to
the left so that the lid will be able to close.
6. Fit the two notches of the back cover to the two slots at
the lower part of the bag housing, and push the back
cover back in place at the housing.
EMPTYING THE CLOTH DUST BAG
Empty the Bag whenever the "Bag Full" Light
comes on. To empty or to replace:
1. Remove cloth bag as above in steps 1-3.
Disconnect the power cord from the electrical outlet. Pull the Dust lid
button (16) and remove the Dust lid outwards to remove it from the
cleaner.
Push downwards at the edge to the left of the plastic holder, so that the
2.
bag loosens from the vacuum inlet of the machine.
Grasp at the plastic fl ange of the bag and gently pull the bag outwards
3.
- away from cleaner.
4. Remove bag clip and shake out bag contents.
5. Put the bag clip back on the bag.
6. Replace clean/new cloth bag into machine and close
back cover as above in step 4-6.
cloth bag into the slot of the bagholder and push the bag in place so
that bag is secured.
Push the bag holder with the new bag upwards, so that the bag inlet
7.
fasten to the inlet of the machine. Make sure that the bag is unfold and
will fi t in place at the bag housing. Also check that the "no bag" clip is
placed to the left so that the lid will be able to close.
Fit the two notches of the back cover to the two slots at the lower part of
8.
the bag housing, and push the back cover back in place at the housing.

MAINTENANCE

indica-
(15)
(15)
Insert the cleaned/new
NOTE!
Photos belows shows changing of the paper dust bags!
Never operate the machine without a Dust Bag in place.
1
2
3 3
4 4
3, 4
5
1
2
5
6
11