System Settings; Restore Default - Nexo NX242 Manuel D'utilisation

22
PAGE

System settings

NX242 USER MANUAL LOAD2_22
DATE : 12/3/2004
MENU DESCRIPTION
2.1 Revision [soft & hard rev]
Displays the revision number of the LOAD; DSP
SOFTWARE; FLASH BOOT; HARDWARE and SERIAL
NUMBER. Turn the encoder to access to the different
revision screens.
Check on our web site
2.2 Security [password]
The user password facility allows switching between "free
access", "unit locked" and "Change password. The factory
default password is NEXO.
This allows you also to get into an INSTALLER menu.
Please contact your NEXO dealer if access required.
2.3 Reserved
This menu was formally used in the NX241 to control the
EARTH LIFT. This function is not available anymore in the
NX242 (due to a change in our "ground plane" politic). To
keep the coherence of the MENUs between NX241 &
NX242 we have nevertheless keep this slot unused.
2.4 SENSE GAIN
Allows switching between line level sense lines and
amplifier level sense lines. (0 or 18dB gain on the sense
line)

2.5 Restore Default

Restores the factory defaults. System related values like
the AMP GAIN and AMP Power will not change.
www.nexo.fr if your unit is updated.