Menu Description; Main Family Selection; User Settings - Nexo NX242 Manuel D'utilisation

MENU DESCRIPTION

On the controller display screen, the number before the Function corresponds to the Menu Number. To
change the first number (this is the Main menu label) button A must be pressed. To change the second
number (this is the Submenu label) button B must be pressed. To select options, turn the encoder wheel,
or press the ENTER button (
stated).
Please refer to the release notes issued with each new download to track eventual menu changes.

Main Family Selection

User settings

USER MANUAL LOAD2_22
DATE: 03/12/2004
MENU DESCRIPTION
-- LOAD2_20 --
(c) NEXO 2004
). Changes are immediate (no validation is required unless clearly
Changing Cabinet Family
In order to prevent end-user changing between different
NEXO system set-ups during use, the following procedure
is obligatory. This procedure has been purposely designed
to avoid any mistake. It is nevertheless very easy to
change set-up among the same family (see menu 3)
Depressing A & B buttons while the NX242 is resetting.
You can reset the unit without powering off by
simultaneously depressing buttons A, B & ENTER (
the same time.
Note: Selecting a new family will set all parameters to
factory default settings.
1.1 HEADROOM
Allows the user to adjust the headroom (8 steps, 3dB each)
before the A/D converter without changing the overall gain
of the processor. Factory default is set to maximum
headroom (and so, maximum noise). This can be adjusted
if you feel the processor is too noisy for lower level
applications.
An Input bar graph meter displays input level and
headroom before input clip. The maximum of the left and
right input is shown on the meter. Note that the meter does
not show DSP clipping.
19
PAGE
) at