How To Pair Two Btx1 Fm Units; Adjusting The Volume; Compatibility With Other Midland Bt Line Units - Midland BTX1 FM Guide D'utilisation

How to pair two BTX1 FM units

The two units supplied in the same BTX1 FM box, are already paired and ready to
use, which mean you don't need to perform this procedure. The unit are already
paired using the Middle button.
If the devices are not part of the same kit, or the units has been purchased sepa-
rately, you need to first pair it in order to use it.
To pair the BTX1 FM to another BTX1 FM unit
To pair the BTX1 FM to another BTX1 FM unit, you must first enter the setup mode:
1. Turn off the unit
2. Press and hold down the middle button about 7 sec., until the Red light is on
permanently.
3. Now press the Middle button for 3 seconds. The Blue and Red light will flash.
4. Do the same procedure on the other unit, When successfully paired, each unit
will have the Blue light on for one second and than go back to the setup mode
(Red light always on).
5. Now the pairing procedure is complete, you just need to exit the setup mode
before you can use the units:
6. Double click on the Middle button, the Red light will turn off and the Blue
light will start flashing.
You can use now your BTX1 FM.
How to use the Intercom
To use the intercom feature, be sure the both units are turned on and correctly
paired together.
Manual activation
Press the Middle button on one of the two units. Communication is enabled and
remains active until you press again the middle button. The intercom need some
second to activate, you will hear a beep tone when the intercom is open.
Voice activation (VOX)
Simply start talking, after some seconds the communication will be opened and
will remain active for the time you are talking. If there is no conversation the
intercom will be closed after 40 seconds. If needed you can close the intercom
manually without waiting 40 seconds (just press the middle button).
A- Manual activation
Mode Forward button
Intercom
If needed, you can disable the VOX feature simply by pressing the Backward but-
ton for 7 sec. A voice announcement will advise you when the VOX is disabled.
To turn the VOX on again, just press the same button and a voice announcement
will advise you that the VOX is now active. This setting is remembered also if you
turn off the unit.

Adjusting the volume

Your Midland BTX1 FM uses AGC technology, which automatically adjusts the
listening volume in relation to background noises.
However, it is also possible to manually adjust the volume by means of the "Volu-
me +" and "Volume -"buttons.
Attention: volume can be adjust only when an audio connection is active.
Attention: the volume buttons (Vol + and Vol -) cannot be used to adjust the vo-
lume of the wired audio source. The AGC system with automatically increase the
volume on higher speed.

Compatibility with other Midland BT line units

The BTX1 FM is compatible with BT Next Conference and BTX2 FM.
When paired the max distance of the intercom is defined from the lower possible.
The BTX1 FM is compatible with the previous line of Midland BT (BT
Next, BTX2 and BTX1) only if updated to firmware version 2014.
Middle button
Short press: Open/Close intercom to paired
raider
Long press: Change mode
Backward button
Long press: Toggle on/off wired
Midland BTX1 FM - 17