Pedal Standard; Pedal Start-Stop; Temperature Regulation - WLD-TEC Fuego SCS Mode D'emploi

3.4 Pedal Standard
The flame is ignited by operation of the foot
pedal. The foot pedal remains depressed for
the duration of use. For the duration of use
the burning time is shown on the display.
The flame is extinguished upon release of
the pedal. (In case of a connected Autoloop
Pro the unit switches over to a special Autoloop program. Please see Autoloop Pro
manual for further information.)
This application program can only be used if the foot pedal is connected.
i
To switch over from the application program "Pedal Standard" to another
program, turn the function knob (1) to the right or to the left.
3.5 Pedal Start-Stop
The flame is ignited by operation of the foot
pedal. The flame is extinguished after rene-
wed actuation of the foot pedal. Additionally
the flame is automatically extinguished when
the burning time has expired. Alternatively
the burner can be stopped by a short push on
the function knob (1). (In case of a connected
Autoloop Pro the unit switches over to a special Autoloop program. Please see
Autoloop Pro manual for further information.) Varying the burning time 1 sec - 2 h:
see paragraph 3.2 "Sensor Auto-Off".
This application program can only be used if the foot pedal is connected.
i
To switch over from the application program "Pedal Start-Stop" to another
program, turn the function knob (1) to the right or to the left.

3.6 Temperature regulation

This application program serves to maintain
constant heating by temperature regulation.
To use this application program a temperature
sensor and measuring adapter must
be connected to the foot pedal socket
(Temperature sensor and measuring adapter
optional accessory). After switching over to
the application program, first the nominal
temperature is adjusted by turning the function knob (1). To memorize, press the
function knob (1). After that, how long the nominal temperature is to be maintained is
adjusted with the timer. To confirm, press the function knob (1).
During the temperature regulation program, the timer only starts to count down
i
once the nominal temperature has been reached.
50
Pedal Standard
Fig. 3.4/1
Pedal Start-Stop
Fig. 3.5/1
Temperature regulation
Connect temperature sensor
Fig. 3.6/1