Opening And Stepping Out (Also In Case Of Emergency); Error Messages And Repair; Warranty/Guarantee/Liability - Atomic NEOX EBM Mode D'emploi

ebm_bindings_5.0 22.09.2004
7. Following the "OK" an animation will appear on the display. You can choose from one of
three options. Your choice will be set by the specialist dealer.
ANIMATION 1
zoom in
ANIMATION 2
scroll
ANIMATION 3
rotation

5.2. Opening and stepping out (also in case of emergency)

8
Press down the heel lever , raise your heel and step out of the binding.

6. Error messages and repair

Display Cause
The binding is not closed Step out of the binding, carefully remove any
(properly). snow, ice, dirt and foreign matter from the boot
soles and interfaces of the boot to the binding
and step back into the binding.
The binding pressure is Step out of the binding and carefully remove
too high. any snow, ice, dirt and foreign matter from the
boot soles and interfaces of the boot to binding
The binding pressure is and step back into the binding. If the error
too low. message appears again, contact a qualified
specialist dealer.
The flashing symbol indi- Contact a qualified specialist dealer to have the
cates that the toe piece bat- battery changed.
tery has run down.
The flashing symbol indi-
cates that the heel unit bat-
tery has run down.
[ ]
e
16
7:58 Uhr Seite 17
Remedy
Display Cause
The flashing symbol indi- The binding is functioning properly! However,
cates that the binding we recommend that you have it serviced by a
needs to be serviced. qualified specialist dealer before you go skiing
again.
Even if the Electronic Binding Management
System is no longer working, the mechanical
No display function of the binding is guaranteed. However,
as the system check cannot be carried out, we
recommend that you do not continue skiing.
7. Mounting and Service
For your binding to function properly, and consequently for your own safety, proper maintenan-
ce and regular service are imperative even if your binding is of high technical quality.
:: We therefore recommend that you have your binding serviced by a qualified specialist dealer
as soon as the service symbol appears.
Transport:
:: Always remove the boot from the binding before transport.
:: The binding should always be protected by a transport box, a binding cover or a ski bag when
being transported on the car roof. Remove the binding protection after transport.
Storage:
:: Always remove the boot from the binding before putting your equipment into storage.
:: Store your skis in a dry room. This helps avoid the danger of corrosion and prevents the
binding from being covered with snow or ice or being penetrated by moisture. To protect the
mechanism, it is advisable to close the heel unit.

8. Warranty/Guarantee/Liability

:: ATOMIC gives a one-year guarantee to the original buyer (final consumer) of the ski binding
calculated from the date of purchase. Within the scope of this guarantee ATOMIC Austria
GmbH will either replace or repair the faulty product or parts thereof or provide a replacement.
:: Bindings must always be mounted by an authorised specialist dealer and adjusted to the
personal settings of the customer. The setting protocol must be given to the customer who
must keep it carefully. Claims for performance under the guarantee for faulty bindings or parts
thereof will only be accepted by ATOMIC Austria GmbH if the setting values with a standard
boot sole do not fall within the tolerances of the ISO standard (wear or dirt on the ski boot
can have a serious negative effect on the binding for example).
Remedy
[ ]
e
17