Operation; General - Hatco HGSm-1P Manuel D'installation Et D'utilisation

OPERATION

General

Use the following procedure to turn on and operate a Heated
Glass Shelf.
WARNING
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
NOTICE
Do not turn on unit until it has been cleaned thoroughly.
Ceramic glass surface must be clear of debris to prevent
burn-on.
Use only wipes, pads, and cleaners designed specifically
for cleaning ceramic glass surfaces. Using other wipes,
pads, or cleaners may damage ceramic glass surface.
Do not slide pans across glass surface, use rough-
bottomed pans, or drop anything on glass surface.
Scratching or breakage may occur. Damage to glass
surface or breakage of glass caused by misuse is not
covered under warranty.
Control Keys
Heated Glass Shelf Control Panel
Startup
1. Using an appropriate cleaning wipe or a damp cloth, clean
and sanitize the glass surface of the unit. Consistent daily
cleaning will keep cleanup easy as well as protect and
preserve the glass surface of the unit.
2. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.
3. Press the key to turn on the unit.
• The heating element will energize.
• The indicator light for the active heat setting will
illuminate.
BURN HAzARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
4. Select the desired heat setting. The corresponding heat
setting indicator light will illuminate to show the selected
setting.
• Press the key to increase the heat setting.
• Press the key to decrease the heat setting.
5. allow the unit 30 minutes to reach operating temperature.
Shutdown
1. Press the key to turn off the unit. The heating element
and indicator light will shut off.
Heat Setting
Indicator Lights
6
English
CAUTION
Form No. HGSmm-0216