Removing A P2 Card - Panasonic AU-XPD3 P2 Mode D'emploi

Removing a P2 Card

1
First confirm that the P2 card is not being
accessed, and then flip up the EJECT
button in the direction of the arrow.
u NOTE:
• To remove a P2 card on a Mac, drag the P2 card
icon to the Trash. Then check that the icon has
disappeared and the access indicator on the P2
drive has turned off before physically removing
the P2 card.
• Do not remove a P2 card that is being accessed. Removing a P2 card
during access may cause the P2 drive to malfunction. Should this happen,
reconnect the Thunderbolt 3 Cable.
2
Press the EJECT button.
The P2 card will slide out far enough to allow you to
remove it.
EJECT button
E-14