3M ReLoad SRL Mode D'emploi page 65

Mode d'emploi • Instrucciones de usuario •
3.0 Maintenance, servicing and storage
3.1 Cleaning:
If required, clean the SRL's exterior with warm water (<100ºF) and non biological detergent. Position the SRL
such that any excess water can drain out. Clean labels as required in order to maintain legibility.
Clean the lanyard with water and non biological detergent. Rinse and towel dry lanyard leaving fully retracted
device to dry naturally in a sheltered and ventilated place. Do not place near sources of heat. An excessive
buildup of dust, dirt and paint, etc., may compromise the retraction of the lanyard. If there is excessive dirt
build-up, the lanyard must be replaced by an authorized person.
WARNING!
If the lanyard comes into contact with acids, remove the unit from service and return
the SRL to an authorized person for lanyard replacement.
Lanyard replacement and any further maintenance must be completed by an authorized person. DO NOT
disassemble the SRL. For inspection intervals please refer to Section 2.1.
NOTE: Authorized person means a person who is trained and approved by 3M to identify hazards or dangerous condi-
tions of the self retracting lanyard.
User instructions
65