Removing/Re-Installing The Cover Of Pushchair Seat - KIDDY Click'n Move 3 Guide D'utilisation

are flat routed, the end clips of hip belts are
placed flat behind rear plate and the end clip of
buckle belt is placed flat under the front slot of
seat plate.

4.8 Removing/re-installing the cover of pushchair seat

To remove the sun roof open the snap fastener at upper frame of push chair seat
(fig. 26)
Open the snap fastener at both sides of sun roof joint (fig. 27; no. 1).
Press both locking buttons (fig. 27; no. 2).
Remove the sun roof by lifting the frame upwards (fig. 27; no. 3).
To remove the Cover of pushchair seat open the snap fastener (fig. 28) and zipper
(fig. 29/30) around the whole frame.
Open both buckles of hip belts and thread it through the cover. (fig. 31; no. 1).
Open the 5 point buckle and thread it through the cover. (fig. 31; no. 2).
Thread the shoulder belts through the cover (fig. 31; no. 3).
Now the cover can removed completely.
To re-install the cover, follow the steps for removing the cover in reverse order.
WARNING
Before using the pushchair seat make sure that
the 5-Point belt system is correctly re-installed
as explained under point 4.7 that the cover is
correctly re-installed and all snap fastener and
zippers are correctly closed.
EN
47 47