Assembling The Unit; Installing The Computer - Elite Cube Digital Notice D'utilisation

EN
• Attention: Integrated wireless systems that
work on the same frequency band can interfere
with the data transmission of the Cube Digital. In
this case, deactivate them.
• Do not leave the unit and console exposed to
direct sunlight or in particularly humid places
for prolonged periods when not being used.
• Never use chemical detergents (petrol or thin-
ners) on any part of the Elite Cube Digital

ASSEMBLING THE UNIT

To fit the unit (ref. A) on the frame, follow the
instructions given in the Frame manual.
Plug the resistance unit (ref. G) into a wall outlet
and into the resistance unit, using the supplied
power cord.

INSTALLING THE COMPUTER

The cycle computer (ref. B) of the Cube Digital can
be fitted on the handlebar or on the handlebar
stem. Fit it where most convenient.
• Open the battery compartment obtained under
the display and insert the CR2032 type battery
located in the box of the computer. Respect the
polarities indicated where the batteries are hou-
sed.
• In every pack there is a support, two different
pairs of clamps (ref. F) and three different O-rings
(ref. F). Hook the computer support (ref. C) to the
bicycle with the O-rings or the clamps, using
those of suitable size for the handlebar. The pack
also contains a rubber (ref.D) to be inserted
between the support and the handlebar, to pre-
vent scratching the bicycle. Fix everything as
shown in the figure.
Attention: Fix the support with the release tab
towards the rider.
20
NOTES
• Fixing to handlebar support with clamps (Fig. 2).
• Fixing to handlebar with clamps (Fig. 3).
• Fixing with O-ring (Fig. 4).
2
3
4