Using The Tools - Kenwood Cooking Chef Guide De Démarrage Rapide

Safety Sensor messages
Safety Sensor messages:
For safety the mixer is fitted with sensors which will operate
when using the mixer in cooking mode.
Error codes (or E codes) will appear on the machines LCD
display accompanied by a beeping sound if an item is not
fitted correctly. These are here to ensure you are using
the machine safely. If this occurs check the following error
messages.
E: 01 – Head lift
If the heat function is selected and the head of the machine is not lowered
correctly or raised during cooking E: 01 will appear.
Solution: Lower the head. Turn the speed control to '0' and start again.
E: 02 – The Bowl
If the bowl of the Cooking Chef is not fitted correctly then E: 02 will appear.
Solution: Check the bowl is fitted correctly. The logo should always
face the front of the machine.
E: 03 – The Heat Shield
If the Heat Shield is not fitted onto the head of the machine and you
select the heating function then E: 03 will appear. You must ensure during
cooking the Heat Shield is on as this protects the gear box.
Solution: Ensure the Heat Shield is fitted correctly. It should push
firmly up under the head of the machine.
E: 04 – Outlet covers
If the slow or medium/high speed outlet covers are not fitted correctly
(these can be found on the top of the machine) the heating function will not
work and E: 04 will appear. However, if you want to use the Cooking Chef
as a standard mixer and not to cook it will continue to work.
Solution: Ensure that all the covers are fitted correctly. Turn the speed
control to '0' and then select desired speed.
For more information see: The DVD "Quick Start Guide" Chapter
or visit www.kenwoodcookingchef.com
8

Using the tools:

For best performance the Power Whisk, K Beater and Stirring Tool should be almost touching the
bottom of the bowl. If necessary the tools can be adjusted. Simply use the spanner provided to adjust
the height of the tool.
Note: The tools need to sit roughly 5mm's above the bottom of the bowl, ensure that the tools are not
lowered too much as they may scratch the bottom of the bowl.
1 2
1 2
Stirring Tool: The Stirring Tool fits onto the machine in a slightly different way compared to the other
tools. Simply line up the slot on the rim of the tool with the metal pin on the underside of the mixer head.
Then, holding the centre paddle of the tool, push the tool into the socket and twist to lock into position.
1 2
En
3
Tip: By using a sheet of paper
you can ensure your whisk is at
the right height.
Place a sheet paper in between
the whisk and bowl. You should
be able to pull the sheet of
paper out with out tearing it.
So the bowl tool sits just above
the bottom of the bowl (but not
touching the bottom).
9