Zwilling ENFINIGY Manuel D'utilisation page 8

Setting
Settings
1 Blooming
Blooming freshly ground coffee improves the taste. When water touches dry ground coffee,
carbon dioxide is released. This impairs the taste of the coffee and prevents the water from
extracting the aroma from the powder. The blooming makes sure that the desired aroma can be
extracted from the coffee during the subsequent brewing process.
Blooming on /off
Turn the button to the left until the
Otherwise, "NO" will appear. Press the button. "YES" or "NO" flashes. Turning the button to the
right activates the blooming, turning it to the left deactivates it. Press the button to confirm your
selection.
If you activate blooming, the ideal blooming amount and the actual brewing process
will be optimised for the selected number of cups. Without blooming, the number of
cups cannot be set, and this is not necessary, as the entire water from the water tank will
be used regardless of whether blooming is active or not.
2 Setting the time
Turn the button to the right until the
be displayed and will flash. Turn the button to set the hour. Press the button. Turn the button to set
the minute. Press the button. Turn the button to the left to return to all other settings.
In the event of a power outage or if the appliance is unplugged, the clock will be reset to 12:00.
3 Setting the timer
For the timer to start the coffee machine at the right time, the clock must be set correctly (see
section 2 ). Turn the button until the
flashes. Turn the button to set the time at which the coffee is to be brewed. Press the button. Turn
the button to set the minute. Press the button again. Now the
brewing process starts.
After setting the timer, fill the water tank and the coffee filter with the desired amount of
water and ground coffee.
If the coffee machine is switched off or in the event of a power outage, the timer will be
deleted.
7
icon flashes. "YES" means that the coffee will be bloomed.
icon flashes. Press the button for three seconds. The time will
symbol flashes. Briefly press the button until the display
will appear continually until the
EN