Using The Emergency Switch; Switching Off The Cooler; Defrosting The Cooler - Dometic GROUP WAECO BordBar CDF-11 Notice D'utilisation

BordBar CDF-11
NOTE
I
When the cooler is supplied by the starter battery, select the battery
monitor mode "HIGH". If the cooler is connected to a supply battery,
the battery monitor mode "LOW" will suffice.
If you wish to operate the cooler from the AC mains, set the battery
monitor to the "LOW" position.
6.10

Using the emergency switch

The device is equipped with an emergency switch. Thus you can keep cool-
ing if an error occurs within the interior electronics.
NOTE
I
During normal operation the emergency switch (fig. 1 12, page 3)
has to be set to the "Normal" position.
➤ If the interior electronics fail: Slide the emergency switch to the "Emergen-
cy" position.
6.11

Switching off the cooler

➤ Empty the cooler.
➤ Switch the cooler off: Press the "ON/OFF" button (fig. 2 1, page 3) for
three seconds.
➤ Pull out the connection cable.
If you do not want to use the cooler for a longer period of time:
➤ Leave the cover slightly open. This prevents odour build-up.
6.12

Defrosting the cooler

Humidity can form frost in the interior of the cooling device or on the vaporis-
er. This reduces the cooling capacity. Defrost the device in good time to avoid
this.
NOTICE! Danger of damaging the device!
A
Never use hard or pointed tools to remove ice or to loosen objects
which have frozen in place.
To defrost the cooler, proceed as follows:
EN
Operation
31