Hama PD-27W60 Mode D'emploi page 4

• Charging begins and ends automatically.
• Charge the Power Pack fully before using it for the first time.
Note – Capacity
• The capacity is always shown when the Power Pack is charging.
• Each status LED corresponds to 25% of the capacity. When an LED is permanently illuminated,
this indicates that this capacity level has already been reached. The Power Pack is charged to at
least 75% if three LEDs are illuminated, and the fourth is flashing.
• If all four status LEDs light up, the full capacity is available.
• Press the button of the Power Pack to switch it on and to check its current capacity.
• The power pack switches off automatically after about 10 seconds.
Warning – Battery
• Only use suitable charging devices or USB connections for charging.
• As a rule, do not charge devices or USB connections that are defective and do not try to repair
them yourself.
• Do not overcharge the product or allow the battery to completely discharge.
• Avoid storing, charging or using batteries in extreme temperatures.
• When stored over a long period of time, batteries should be charged regularly (at least every
three months).
4.2 Charging terminal devices
• Connect the included USB Type-C charging cable to the power pack's USB Type-C connection
(see 8. Technical Data) and to the USB Type-C connection of your terminal device (smartphone,
tablet, notebook, etc.) to charge your terminal device with Power Delivery. Alternatively, connect
a suitable charging cable for your terminal device to one of the two USB outputs to charge your
terminal device.
• Charging begins automatically. The status LEDs show the remaining capacity when the Power Pack
is charging.
• The current battery status of your terminal device will appear on this device.
• Charging ends automatically. Then disconnect the power pack from your terminal device.
• The Power Pack will automatically switch off if it is not connected to a terminal device.
Warning – Connecting terminal devices
• Before connecting a terminal device, check whether the power output of the charger can supply
sufficient power for the device.
• Ensure that the total power consumption of the connected terminal device does not exceed the
limit value (see point 8 Technical Data).
• Please refer to the instructions in the operating manual of your terminal device.
• It is essential that you observe these specifications and the safety instructions regarding the
power supply of your devices.
• The power pack must not be charged and discharged at the same time!
Note – Optimised charging
• Optimised charging means that the Power Pack recognises the connected terminal device and
supplies it with the optimal current to minimise charging time.
3