Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Use of joystick
The wheelchair moving
direction is controlled by
joystick. The moving extent
of joystick also controls the
GB
moving speed.
Please turn on or turn off the power
when the joystick is in the middle
position. Otherwise the controller will
let out wrong operation signal.
Release the joystick to middle, this
mistake will stop. If the mistake is still
continuing, perhaps this part is malfun-
ction, do not use it and contact with
your dealer for maintenance.
7. Maintenance
Maintenance of wheelchair includes clean
wheelchair, check wheel and battery, and
charge battery. For further maintenance
please contact with your dealer. Our sugge-
stion is checking the wheelchair every half
year, annually overhaul.
7.1 Clean and Battery Maintenance
Clean Wheelchair
Please clean the wheelchair regularly.
Clean the parts which are frequently
touched with user's body (such as set
cushion, armrest, controller) by a clean and
slight wet cloth. Do not use organic solvents
to clean.
If it is a patient user, the wheelchair should
be cleaned once per week. If the wheelchair
is used by an infectious victim, it should be
cleaned and disinfected by disinfectants.
36
Wheels
Check the tires' heir wear condition regu-
larly. When the tire tread pattern depth
reduces to 1mm, please replace new tire.
Battery
To make sure that the battery is fully
charged frequently. In order to prolong
battery life, we strongly recommend users
do not to charge until battery run out of
power totally.
7.2 Wheelchair Malfunction and Checking
When malfunctions happen during the
wheelchair is working, please turn off the
power before check. Symptom: completely
lose power, and all the LED lights on the
controller panel are off.
Check Step:
Step 1: To check if the controller's plug is
loose.
Step 2: To check if the connection of cont-
roller's plug and battery box is loose. Please
reinsert the plug connector (hold the plug
when pull out the plug. Do not pull the wire
to avoid unnecessary damage to the wire
line). After above checking, if the wheelchair
is still not able to restore the power, or if
users have any question for above checking,
please connect with your dealer.
The controller has a diagnosing system
to monitor the controller and motor.
Any malfunction of these parts is
indicated by the controller. For more
details, please kindly refer to chapter of
audio signal indication.
7.3 Maintenance Checking
The following is a checking list. Electric
wheelchair should be ordinal checked
according to our suggestion. When you
get on or get off the wheelchair, some self
checking is done automatically. For more
your attention, we particularly list these self-
checking items in A area.
A area
Before use, please check if
following parts are correct:
1.Backrest
2. Armrest
3. Controller position
4.Footrest
5. battery power
6.Clutch/adjusting lever for
conversion between manual
mode and electric mode
B area
Check the following parts
monthly, to avoid original
parts loosing or wearing
1. Screws
2. Brakes
3. Clutch/adjusting lever for
conversion between manual
mode and electric mode
4. The front and rear wheels
and their tread pattern depth
5. Connectors' of controller
and charger
C area
For safety, semiannual overall
maintenance is needed.
8. Others
Condition for Transport and Storage-
During transport and storage, the electric
wheelchair should be correctly placed as
labeled indication.
•
Transportation should be avoided
moisture and sunlight and away from
heat resource.
•
In case of electric parts are damaged due
to damp, please avoid storing the wheel-
chair in rain, outdoor and moisture.
•
Storage condition:
- Environment temperature
-40° C +55° C
- Relative humidity ≤80%
- Air Pressure 86kPa ~ 106kPa.
37
GB
Publicité
Table des Matières
