Application Of The Balancer - Delachaux CONDUCTIX wampfler 040874-x2,0 Série Instructions D'utilisation

Operating Instructions
Balancer
040874-...x2,0
3

Application of the balancer

•
After having attached the load, verify if the working conditions are accurate (easy pullout).
•
For a safety use, the upper suspensions, the hook (33) and the safety hook have to be
controlled regularly.
If screws are used, the self-closing system and/or the splint have to be verified.
Control also the installed brackets as well as the total safety suspension (S).
Control regularly the wear of the supporting parts (spring safety hook, wire, parts of the suspension and connection of
the tool).
The spring of the safety hook (29) and of the hook (33) have to be kept in working order.
The safety lock must close properly.
Verification:
Verify the complete wire.
- Damage A (break of a few cores only) : the wire can be still
used.
- Damage B or C (break of a wire strand) : the wire has to be
replaced immediately.
(Drawing I)
Maintenance on the installed balancer:
- Grease with wire grease (BEACON 325 from ESSO, or equivalent grease)
Exceptional maintenance of the balancer:
Before taking the load from the balancer, the wire must be completely retracted;
-
the rubber stop must lie on the guiding surface.
A pulled off wire, with stressed spring, may resile very fast and cause personal
-
injury or material damages.
Be very careful, when taking the balancer from the bracket!
-
BAL0400-0072a-D/E/F
www.conductix.com
Drawing I
Seite 17 von 29