Installation Of The Hose - Delachaux Conductix-Wampfler 040449-06x5,0 Instructions D'utilisation

Operating Instructions
Hose Reel
040449-...
Winding off the hose:
•
Wind off the hose until the desired length.
The hose reel can be stopped at any time, if you hear any click noise.
There are 16 possibilities for each rotation.
•
After stopping, it is possible to operate the hose non tension.
Coiling up of the hose:
•
Draw the hose approx. ¼ turn forward (release the lock);
Now the hose is coiling up automatically.
Caution: For security reason and in order to avoid any injury and damages on the hose reel, guide the
hose manually.
If required, the „lock" can be disconnected:
- stop the reel, with complete coiled up hose,
- release the counter nut (Pos. 80),
- hold the hose by hand,
- turn in the grid bolt (screw thread pin with a slot) with a screw driver until the stop is
unoperative (hose is permanently live),
- tighten the counter nut (Pos. 80).
4

Installation of the hose

Installation of the hose (if the reel has been delivered without hose)
•
Adjust the drum manually to the limit stop, towards the shaft. Refer to the red coloured label on the drum.
2-3 turns can be left, in order to allow a later tightening of the spring.
Caution: The drum is spring pressured!
Never release because of injury danger and spring damages risks!
•
Lock the drum to secure against resiling.
•
Attach the hose.
•
Draw the hose approx. ¼ turn forward (unlock);
The hose is now coiling up automatically.
Caution: For security reason and in order to avoid any injury and damages on the hose reel, guide the
hose manually.
Replacement of the hose:
•
Wind off the hose completely from the reel and stop the drum.
•
Replace the hose.
•
Unlock the drum; the hose is drawn on automatically.
Caution: For security reason and in order to avoid any injury and damages on the hose reel, guide the hose
manually.
BAL0400-0057b-D/E/F
www.conductix.com Seite 11 von 20