Service; Characteristics - Delachaux Conductix-Wampfler 040449-06x5,0 Instructions D'utilisation

Operating Instructions
Hose Reel
040449-...
7

Service

Caution: The spiral flat spring must be completely released before any recondition work!
How to demount the hose reel:
•
Disconnect the hose reel from the supply of fluid or gas.
•
Draw the hose completely from the reel. Stop the drum (Pos. 110).
•
Detach the hose with the reinforcement (Pos. 170).
•
Take off the reel and release the spiral spring by bringing the drum to a halt manually.
Caution: Never loose the drum! The spring tension may provoke an injury and spring damages!
•
Release the threaded pin (Pos. 12) and take off the support (Pos. 10).
•
Remove the drum: the spring cover (Pos. 210) must face upwards.
•
Unscrew the spring cover and take it off carefully.
•
Carefully take off the spiral flat spring (Pos. 200) and secure it against springing out.
•
Release the counter nut (Pos. 80) and the screws (Pos. 100): now take off the complete screening.
•
Remove the retaining ring (Pos. 20) and remove the rotating body (Pos. 130)
•
Remove the rings (Pos. 150).
How to mount the hose reel:
Assemble the hose reel in opposite sequences.
For the installation of the hose, refer to the chapter "Installation of the hose".
Instruction: If the hose has not to be completely coiled up on the drum, the spring tension
must be adjusted: refer to the chapter "Adjustment of the spring tension".
How to clear faults:
Fault
The hose doesn't coil up completely
The hose reel is permeable
The hose reel doesn't stop or doesn't
stop properly
8

Characteristics

Order number
040449-06x5,0
040449-09x3,0
BAL0400-0057b-D/E/F
www.conductix.com
Possible cause
Insufficient spring tension
Rings are damaged
The grid spring
Hose NW (mm) Winding length (m)
6
9
Clearance
Tension again the spiral flat spring (chapter 5 "Adjustment
of the spring tension")
Rings (chapter "Service")
Replace the grid spring
Pressure (bar)
5
20
3
Weight (kg)
3,5
Seite 13 von 20