Delachaux CONDUCTIX wampfler 040874-x2,0 Série Instructions D'utilisation page 16

Operating Instructions
Balancer
040874-...x2,0
If a load which is to small has been suspended, the washer
(D) should be even locked.
This happens principally in the upper
pullout area and can be recognised through the 4-6 mm
protruding of the screw (9).
(Drawing H)
To eliminate this fault, proceed as it follows,:
1) Turn the screw (9) clockwise, min. 20 turns, by the means of a 6 mm socket wrench (10).
The torque of the spring-type terminal moves the shaft (22), the gear (19) and the screw (9) upward.
The screw end locks the safety device (13), whereby the torque of the drum is released again.
2) Restrict the pullout to a minimum by adjusting the clamp (42) upward. If thereby the
drum does not release, a balancer with a smaller load capacity must be installed.
For the adjustment of the counterweight screw (9):
- turn clockwise with a socket-wrench (10), to increase the load capacity
- turn counter clockwise, to reduce the load capacity (drawing A).
After the load has been adjusted, verify if the wire (28) moves freely: the complete stressed spring (27) must not limit the
pullout.
•
During the operation, the wire must not be pulled up to the stopper.
It has to stop at min. 30 mm before the lifting end position (drawing A).
•
If necessary, move and lock the clamp, to limit the course upward.
•
To lock the load at the required height, turn the screw (6) at 90° (pos. A, drawing E).
Thereon pay attention, the screw (6) reaches the end position.
The rotation can only occur by pushing with the screwdriver (drawing E).
To loosen the locking, repeat the procedure in reverse order.
This must only occur with a hanging load.
Otherwise a dangerous impact may occur, caused by the resiling wire.
BAL0400-0072a-D/E/F
www.conductix.com
Drawing H
Seite 16 von 29