Franklin Chef FIM35 Manuel De L'utilisateur page 23

3. Keep the ice maker connected to the water supply. Pour 8 oz. of Nickel-Safe Ice
Maker Cleaner Solution into the water trough. After about 5 minutes, initiate the
wash cycle at the ICE/OFF/WASH switch by switching it to the WASH position.
The machine will run the Automatic Clean mode.
4 Allow 30 minutes for proper cleaning. After cleaning, turn the machine OFF at the
.
ICE/OFF/WASH selector switch. Drain off the waste water to a container by means
of the drain pipe at the front of the water trough.
NOTE: Don' t drain off the waste water to the inside of the cabinet.
5. Repeat steps 3 and 4 (without Ice Maker Cleaning Solution) to rinse the ice making
system 3 times.
NOTE: The use of the Ice Maker Cleaner Solution in the water trough during the
rinse is not needed.
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner products.
Use rubber gloves to protect hands. Carefully read the material safety
instructions on the container of the ice machine cleaner.
DISCARD the first batch of ice produced after cleaning.
6. Prepare a sanitizing solution made of 1 ounce of household bleach and 2 gallons of
hot water (95º to 115º F). Wipe the entire bin inside and out, covering every wall
surface.
7. Fill a spray bottle with the sanitizing solution and spray all corners and edges, making
sure to cover all surfaces with the solution.
8. Allow the solution to be in contact for at least 3 minutes, then dry.
9. Repeat step 5 to rinse the ice making system one more time.
10. Put the ICE/OFF/WASH switch in the ICE position. The machine will return to the
regular ice making mode. Discard the first batch of ice.
21